Openais Nightmare Deepseek R1 On A Raspberry Pi

By hairstyler On Nov 13, 2025

Running Deepseek On A Raspberry Pi - Pi My Life Up

Running Deepseek On A Raspberry Pi - Pi My Life Up Most gamers used fraps tool to measure the fps of a game. fraps is a game video recording application, although it also has the ability to display an fps counter over the current game. These tests show the numbers reported by the software, but i don't know if i actually see 67 frames per second on my display. this is kinda the point of my question. in game fps counters show the unlimited count which reaches upwards of 200 fps but i'm pretty sure there's no way my monitor is displaying frames at that speed.

OpenAI’s Nightmare: Deepseek R1 On A Raspberry Pi | Generative AI

OpenAI’s Nightmare: Deepseek R1 On A Raspberry Pi | Generative AI When i run ffprobe input.m2v, fps is reported as 25 even when the frame rate of the video stream is known to have a (constant) frame rate of e.g. 24000/1001 fps: input #0, mpegvideo, from 'test.m2v. Is there any way to display the current monitor refresh rate? i have a monitor that supports freesync, and an nvidia graphics card on windows 10. i have enabled g sync compatible in nvidia settings. My vg27vq monitor has a feature that can display the fps on the screen. whenever i have my second monitor enabled, the fps is 60. without the second monitor, it says 120 fps. is there a reason for. According to the informations which i have found i have tried to enable fps counter using chrome://flags and settings but i haven't found such option. how to do it ?.

OpenAI’s Nightmare: Deepseek R1 On A Raspberry Pi | By Anirban Roy ...

OpenAI’s Nightmare: Deepseek R1 On A Raspberry Pi | By Anirban Roy ... My vg27vq monitor has a feature that can display the fps on the screen. whenever i have my second monitor enabled, the fps is 60. without the second monitor, it says 120 fps. is there a reason for. According to the informations which i have found i have tried to enable fps counter using chrome://flags and settings but i haven't found such option. how to do it ?. This results in my fps going from 120 to 20. after 14 seconds i'm back at 120 fps. i don't know what's up with the gpu mem clk being max, but it is like that in all games (even those that works fine). in some games, the gpu usage constantly goes between 10 and 100 and so does the fps. A quickcam® pro 9000 can physically output 30 fps at 640x480 resolution, 30 fps at 800x600 resolution, and 15 fps at 960x720 resolution (mjpg). for most applications, you will be limited to approximately 10 fps (usb bandwidth limitation of 12 mbps), unless your camera is detected as an enhanced usb 2.0 device (480 mbps). 0 you need to "reencode" your subtitles. it's an option on most subtitle software, like jubler. check your video for fps rate (usually in tools>video information), there's a good chance your video is 23.97 and your subtitles are set for 24 or 25. However, when i use vlc as well as when i tried it with some security camera dvr software (ispy, which i just downloaded to test) vlc defaults to 800x600 (with poor latency), and forcing it to 16:9 1920x1080 plays it at about 10 fps with about a half second latency. the way i'm using vlc to view the capture device video stream is:.